The 3500/15 AC power module and DC power module are half-height modules and must be installed in the designated slot on the left side of the frame. The 3500 rack can contain any combination of one or two power supplies, AC and DC

Flow. Any kind of power supply can power the entire rack. When two power supplies are installed in the rack, the power slot at the bottom serves as the main power supply, while the other one in the upper slot acts as a backup supply. If installed,

The two power supplies are the main ones for backup.

Plugging or unplugging any power module will not stop the machine. The rack can operate normally as long as a second power supply is installed. The 3500/15 AC and DC power supplies accept a wide range of input voltages and convert them into acceptable voltages.

For others to use the 3500 module. The power supply that comes with 3500 includes the following series of mechanical protection systems:

General-purpose AC power supply

High-voltage direct current power supply

Low-voltage DC power supply

The output voltage provided by the system is proportional to the voltage. The distance between the probe tip and the observed conductive surface measures both static (position) and dynamic (vibration) values. The system is mainly applied to the vibration and position of fluid membranes

Measure the bearing machine, as well as the key phase * reference and speed measurement 3. The 3300 XL 8mm system offers the most advanced performance in our eddy current proximity sensor system. Standard 3300 XL 8mm 5

The system also fully complies with the mechanical configuration, linear range, accuracy, and temperature stability of the American Petroleum Institute (API) 670 Standard (4th Edition). All 3300 XL 8mm proximity sensor systems offer this

First-level performance and full interchangeability of supported probes, expansion cables and Proximitor sensors, no need to match or bench calibrate individual components.

Each 3300 XL 8mm sensor system component is backward compatible and interchangeable with other non-XI 3300 series 5mm and 8mm sensor systems components5. This compatibility includes 3,305 millimeters

Probe, used for applicatio

The Bently Nevada 3300/20 is a dual-thrust position monitoring system developed by Bently Nevada. The dual thrust position monitor detects thrust bearing faults early. It continuously measures and monitors

Two independent channels at the axial position related to the axial clearance of the machine.