Description:
Description:
DS200TCDAG1A is GE Mark V series board. It is a Digital I/O Board (TCDA), located in the digital I/O cores <O11>,<051> and<Q21> if present TCDA processes digital contact input signals from the DTBA andDTBB terminal boards and contact output (relay/solenoid) signals from the two TCRA boards. The signals are transmitted over the IONET to the TCOC board in<R1>,<R2> if<021> is installed and the CTBA terminal board in <R5>.
Hardware. There are eight hardware jumpers on the DS200TCDAG1A board. Jl and J8 are forfactory test. J2 and J3 are for IONET termination resistors. J4, J5. and J6 are used to set up the IONET ID for the board. J7 is the stall timer enable. Refer to Appendix A and the hardware jumper screen on the operator interface for information on the hardware jumper settings for this board.
Software. DS200TCDAG1A I/O configuration constants for the contact input inversions are entered in the I/O Configuration Editor located on the HMI as described below.
BENEFITS:
Warranty: 12 months.
Lead time: 1-2 working days.
Terms of payment:Paypal, T/T and Western Union.
Courier partners: DHL, UPS, TNT, FedEx and EMS.
Technical specification, manuals and data sheets
Description:
DS200TCDAG1A is GE Mark V series board. It is a Digital I/O Board (TCDA), located in the digital I/O cores <O11>,<051> and<Q21> if present TCDA processes digital contact input signals from the DTBA andDTBB terminal boards and contact output (relay/solenoid) signals from the two TCRA boards. The signals are transmitted over the IONET to the TCOC board in<R1>,<R2> if<021> is installed and the CTBA terminal board in <R5>.
Hardware. There are eight hardware jumpers on the DS200TCDAG1A board. Jl and J8 are forfactory test. J2 and J3 are for IONET termination resistors. J4, J5. and J6 are used to set up the IONET ID for the board. J7 is the stall timer enable. Refer to Appendix A and the hardware jumper screen on the operator interface for information on the hardware jumper settings for this board.
Software. DS200TCDAG1A I/O configuration constants for the contact input inversions are entered in the I/O Configuration Editor located on the HMI as described below.
BENEFITS:
Warranty: 12 months.
Lead time: 1-2 working days.
Terms of payment:Paypal, T/T and Western Union.
Courier partners: DHL, UPS, TNT, FedEx and EMS.
Technical specification, manuals and data sheets
Each of the five 28 V dc power modules supplies a section of the VME rack. These sections are labeled A,B,C,D, E, and F. The P28C output or PS28 at the bottom ofthe power supply can be used to power an external peripheral device. To do this the jumper plug shown on the bracket to the left of the rack must be moved from the Noral position to the lsolated position below.The fan is only used when the controller is mounted in the rack. It is powered fromthe top connector on the same bracket, located on the left side of the rack.
Related items:
IS2020RKPSG2A
IS215VPROH2BC
IS200VTCCH1CBB
IS200VCRCH1BBB
IS200VRTDH1DAB
IS200VAICH1DAA
IS200VTURH1BAA
IS200VVIBH1CAB
IS200VSVOH1BDC
IS215VCMIH2CC
IS215UCVEH2AE
IS200VTURH1BAB
There are no reviews yet.